How about learning to repair solar street lights

How to design a solar street light project?

Your solar street light project should provide a solution that can help solve these problems such as the use of reflective and refractive non-imaging optics or New concept of LED luminaire. You will need to include your entire lighting analysis and layout in the solar street light project proposal under the design phase.

What if the street light system is not in use?

When the street light system is not in use, the battery cannot be placed for a long time, and it needs to be discharged and charged regularly to keep it active. 3- Regularly inspect the working status of the street light poles. If there is any scratch that causes the anti-rust coating to fall off, it should be repaired in time.

How long do solar street lamps last?

1-Solar panels are the components with the longest service life in solar street lamps and generally have a service life of more than 25 years. During use, if there is dust and fallen leaves on the surface of the components, it will affect the power generation efficiency.

How to replace a street lamp?

1) Make sure the street lamp lead wire is not shorted or open. 2) Check whether the lamp beads of the street lamp are burned or have dirt residue, and the street lamp should be replaced with a new one and cleaned in time. 3) The working life of the street lamp is exhausted, so replace it with a new one in time.

Can a street light be installed on one side of a road?

1) On some roads, street lights are installed on one side of the road, and some roads are equipped with street lights on both sides of the road. This data sheet is suitable for one side of the road. In this case, the 5W street lamp, installation on 3 meters lamp pole, when install on one side of the road, is suitable for a 3 to 4 meters width road.

How do you wire a solar lamp?

Lamp pole threading: use thin iron wire to pass the matching lamp cable through the lamp pole and then lead it out through the hole of the lamp arm. Solar lamp arm threading: Use a thin iron wire to lead the lead wire of the light source out of the lamp arm, and remove the insulation at both ends of the wire for wiring.